![]() If just one tooth is bent out, the trimer will not work correctly. Remove the old blades, insert a new set that you have ensured are compatible with the trimmer, and secure them again. Remember the position they were in before removing them. You will have to open the housing to access the screws, bolts, or nuts that secure the blades. If the blade is broken, replace it before resuming your work. If some teeth are bent, you will need to replace them to make your trimmer work properly. This debris can be pulled out manually if this does not work, use the wooden dowel to detach the pieces a bit. Place the trimmer on a flat surface and look for any wooden debris attached between the teeth. In this step, it is essential for you to put on protective gloves. If you see any damage or fracture on the blades, you will have to replace them. Large branches can be removed by hand, and you can use the pruning shears for tough branches. You have to check the blades, look for leaves and branches stuck in them. When trimming thick pieces, the blades could get jammed due to collected debris. The most common issue with a hedge trimmer is jammed blades. Keep in mind this step is crucial to prevent any disaster, as you will not start the trimmer by accident. Make sure the hedge trimmer is turned off and unplugged, and if your trimmer is gas-powered, make sure the spark plug is disconnected. Cleaner, soapy water could also do the job.īeing safe is a priority.Protective gear, like boots, gloves, and protective eyewear.Just follow the procedures below and always be careful not to hurt yourself. But, as I have mentioned before, there are methods for securely and efficiently unjamming your hedge trimmer. If you need a simple fix, you can always call a professional to get the job done. This article will cover in more detail what to do when your hedge trimmer gets stuck, how to avoid this issue, and how to give maintenance to your hedge trimmer. Check the blades and if severely damaged, change them. Use protecting gloves to avoid being cut by sharp blades. A piece of wooden dowel can be helpful to remove wood or leaves lodged between the teeth of the blade. Next, lay the trimmer on an eve surface and check if a lot of debris got stuck on the blade’s teeth. In Short: If some branches and leaves got stuck, use a tree pruning shear to cut these away. These signs of wear cause debris to get trapped in the cutting mechanism.Īlways make sure the hedge trimmer is completely turned off and disconnected! Then, Check the blades to see the reason for them to be jammed. If debris is causing the blades to stop moving, make sure to completely remove it and clean the blades thoroughly. Starting to show signs of it being worn out is presumed to be the most common one. The probabilities of getting a hedge hammer jammed are pretty high, and it does not matter if you are using an electric or gas-powered trimmer. If you make a purchase through links from this website, we may get a small share of the sale from Amazon and other similar affiliate programs. As an Amazon Associate we earn from qualifying purchases made on our website.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |