** MARVELL BOARD: Synology Disk Station LE Device boots but hangs up on kernel boot: I flashed memory with image composed of 212jboot+210jrd+210jzimage. Update: I searched within various PAT update files and found DS212j uboot, thought it's worth trying because of similar CPU/mem architecture. No change after 20min, i suppose won't boot :)Įdited 1 time(s). Image Type: ARM Linux RAMDisk Image (gzip compressed) # Loading init Ramdisk from Legacy Image at 08000000. Image Type: ARM Linux Kernel Image (uncompressed) # Booting kernel from Legacy Image at 02000000. TFTP error: First block is not block 1 (0) *** Warning - readenv() failed, using default environment Tried to kickstart using NSA310 uboot and TFTPd 210's zimage+rd: Weird, as according to Syno's website 210j and 211j are equipped with same hw base components - 88F6281+DDR2 128 MB. Unfortunately, box does not boot from this image. There might be a Synology procdure to restore to factory (either in u-boot or in Linux). Once you are in Debian, it is easier to make sure the SPI flash is working and can be flashed to. We need the DTB for this DS210j box from somewhere. Boot into Debian on USB from the NSA310 u-boot. kwboot it and flash it in u-boot console.Ģ. It will not work (the u-boot image was built for NAND flash).ġ. > can i just merge it with DS210's dedicated rd, > Noob question - since i found working uboot image, No, since the NSA310 use NAND flash, there is no SPI configured in this u-boot. > moment? Since old flash chip was fried i'm afraid > Should i see SPI flash memory in log at this > *** Warning - readenv() failed, using default Usually we can boot a larger RAM Kirkwood u-boot on a box, if the DDR is the same type and speed (e.g. Note that it's not only the RAM size, but the DDR type also, that caused the hang. > were not able to boot at all or hanged during ram > Used kwboot and only kwb which worked was See here how to extract to mtd0 from flash, and how to use serial consle to boot with mtd0. > give a hint how to extract such information? > Does anyone can confirm first memory layout, or > This layout seemed more reasonable to me. > When looked at bootlogs of other similiar This DS210j board is Marvell Kirkwood 88F6281, so the bootloader for DS213 might work. > bootloader image intended for this particular > Is it possible to download or compile stock > i couldn't find bootloader in none of update files. > extract rd and zimage from syno PAT update, This layout seemed more reasonable to me.ĭoes anyone can confirm first memory layout, or give a hint how to extract such information?Įdited 1 time(s). When looked at bootlogs of other similiar devices, like ds110j: Which is weird because of redboot placed not at 0x00 flash addr. Googled for ds210j bootlogs, found something: Is it possible to download or compile stock bootloader image intended for this particular board/CPU? (88F6-BIA2)Īnother problem was about finding memory layout. Altough i've managed to extract rd and zimage from syno PAT update, i couldn't find bootloader in none of update files. No sings of life from debug console.įound that flash chip is damaged - stayed quite hot when touched and i wasn't able to read/erase/write it in external programmer due to overcurrent error.Īppeared that i need new chip (25P32) programmed with rebuilt image. Went dead suddenly, currently only blue led blinks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |